HID FARGO HDP 6600 X002200 User Manual page 78

Setting
Transfer EOF
Transfer Temp Offset
Encoder Flip Angle
Print Flip Angle
Print Flip Level
Ribbon Print Take-up Tension
Ribbon Print Supply Tension
78
Printing preferences
Description
Print the alignment self-test card.
Setting the Transfer EOF to a positive number causes the image length to grow.
Setting the Transfer EOF to a negative number causes the image length to shorten.
Both the printer and the printer software driver control the built-in transfer roller.
To change the temperature of the transfer roller, adjust the temperature through the
Image Transfer selection within the Advanced tab of the printer preferences. Once
adjusted, the new temperature setting is sent down with the next print job along
with the rest of the printer driver information.
Before printing begins, the transfer roller automatically adjusts to the new
temperature setting. This new temperature setting remains programmed within the
printer until it is once again changed within the printer driver or until the printer is
turned off.
Whenever the printer is turned OFF, the transfer roller automatically resets and
returns to the default temperature the next time the printer is turned ON.
Disconnect the printer power supply.
Technician Note: Cycling the printer power supply serves to reset the transfer roller
to its default temperature. The temperature setting within the printer driver,
however stays the same until it is changed.
DANGER: The printer transfer roller can reach temperatures exceeding 350°F
(175°C). Use extreme caution when operating the transfer roller. Never
touch the transfer roller unless the printer power has been turned off
for at least 20 minutes.
DANGER: Le rouleau de transfert de l'imprimante peut atteindre des
températures supérieures à 350°F (175°C). Soyez extrêmement
prudent lorsque vous utilisez le rouleau de transfert. Ne touchez
jamais le rouleau de transfert à moins que l'alimentation de
l'imprimante a été éteint pendant au moins 20 minutes.
Use this setting to fine tune the position of the flipper.
Note: Only used if encoder is present.
Use this option to set the position of the flipper so it is level with the card path after
a flip operation.
Use this setting to fine tune the home position of the flipper if cards have difficulty
moving from the printer into the flipper.
This controls the tension of the color ribbon during printing. Adjust the ribbon
tension if ribbon wrinkle is appearing on the card.
Note: Adjustments moderately change the image length.
This controls the supply side tension of the color ribbon during printing. Adjust the
ribbon tension if ribbon wrinkle is appearing on the card.
PLT-02931, Rev. A.0
September 2018