HID FARGO HDP 6600 X002200 User Manual page 79

PLT-02931, Rev. A.0
Setting
Film Stretch Compensation
Alternative Mag Verify
Mag Hico DAC Adj
Mag Loco DAC Adj
Resin Heat Adjust
Sleep Time Heater Off
Sleep Time Heater Low Power
Blush Point
Film Takeup Transfer Tension
Film Print Supply Tension
Cleaning Rate
Transfer Heat Dissipation Level
EAT Disable
Beep Disable
eSTANDBY_TEMP
Flipper Offset Mag
Image Length
Internal Encoder offset in mm
September 2018
Description
When printing, the position of the image on the film can vary depending on whether
the previous film panel is used or not. Adjust this setting if the first card after an
error is shifted from the rest.
If set to 1, enables a quicker mag verification step of just looking for any data
encoded on the card. If set to 0 verifies all data written to the card.
Fine tunes the mag drive current for high-coercivity/super coercivity cards. Adjust if
mag verify errors start occurring with new card stock.
Fine tunes the mag drive current for low-coercivity/medium-coercivity cards. Adjust
if mag verify errors start occurring with new card stock.
Print the resin self-test card.
Use this adjustment for black resin text and barcodes that appear faded or too light
or dark.
This setting adjusts how many minutes after the printer goes idle or enters a low
power state that the printer goes into a heater off power state.
This setting adjusts how many minutes after the printer goes idle, the printer goes
into a low power state.
The blush point is compensation during printing:
There is no dye transfer.
There is no light gray line on a portion of the card.
It should be white.
Negative adjustments can cause card jams.
Positive adjustments can help stop jamming.
Note: Adjustments affect flash and smudge.
Important: The film drive sets the baseline for the film tension and should not be
adjusted by the reseller or the end user.
Note: Adjustments moderately change the image length.
This adjustment changes the cleaning rate from 2000 to the new setting.
This setting adjusts when the transfer fan turns on.
0, 1, and 2 - Transfer fan is on only during transfer.
3 - Transfer fan turns on when transfer roller comes up to temp.
4 - Transfer fan always on when not in sleep mode.
Environmentally Adaptive Transfer (EAT) automatically adjusts the transfer
temperature based on the ambient air conditions within the printer.
This is an ON (1) or OFF (0) switch.
Note: Settings can increase or decrease the transfer roller temperature by as much
as 68°F (20°C) in extreme conditions.
This setting disables the beep the printer generates after an EE setting is updated.
This option changes the temperature used when the printer is in standby mode.
This setting fine tunes the position of the flipper relative to the mag encoder. Only
use if a mag encoder is installed.
Fine tunes the length of the image on the card. Increase this value if the image
length is too short. Decrease this value if the image length is too long.
Fine tunes the position of the card when docking into Bay 0.
Printing preferences
79