HID FARGO HDP 6600 X002200 User Manual page 109

PLT-02931, Rev. A.0
Printer Display Error Message
Failed to Initialize
Error Message No. 455, 456
Check Options File
Error Message No. 458
No Film
Error Message No. 498
Ribbon Tag Error
Error Message No. 524
Heater Error
Error Message No. 558, 559
Flipper Jam
Error Message No. 480, 481
Head Resistance
Error Message No. 434
See Manual
Error Message No. 435, 440
Headlift Error
Error Message No. 436, 437, 442, 443
Heater Error
Error Message No. 551, 557
Invalid Ribbon
Error Message No. 519
September 2018
Cause
An error has occurred during printer
start up.
Printer not set up correctly or
hardware failure.
Error reading film tag.
Error reading ribbon tag.
The flattener is too hot.
A card is jammed in the card flipping
area of the printer.
The flipper table is jammed or
non-functional.
The EE setting in printer driver for
head resistance is out of range.
A hardware fault has prevented
setting the correct printhead voltage.
This is a problem with the printhead
lift.
The transfer heater roller is too hot.
An unauthorized ribbon is installed in
the printer.
Troubleshooting
Solution
Reset the printer and try again. If
problem persists, call for technical
assistance.
Reset the printer and try again. If
problem persists, call for technical
assistance.
Reset the printer and try again. If
problem persists, call for technical
assistance.
Reset the printer and try again. If
problem persists, call for technical
assistance.
Reset the printer and try again. If
problem persists, call for technical
assistance.
Open the printer flipping module
cover.
Clear any cards in the flipping
module by opening the printer cover
and pressing the Forward and/or
Back buttons located on the printer
display.
Ensure that the flipper module can
rotate freely. Close the printer
flipping module cover.
Press Resume on the printer display
to continue printing.
To cancel the print, click Cancel Print
from the HID Printer Status Monitor.
Enter a value for Head Resistance in
the EE settings in the printer driver.
Reset the correct value according to
the steps in Section 3.4.8 Internal
printer settings. If this problem
persists, call for technical assistance.
Verify Head Resistance EE setting is
correct.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
Get the correct ribbon from your
dealer.
109