HID FARGO HDP 6600 X002200 User Manual page 115

PLT-02931, Rev. A.0
Printer Error Message
Ribbon Break/Jam, Check Ribbon
Check Film
Invalid Film
September 2018
Cause
A ribbon break/jam has been
detected inside the printer.
A film break/jam has been detected
inside the printer.
An incorrect print ribbon/print film
has been installed in the printer. (This
is if you are using SecureMark™ ribbon
and film.)
Troubleshooting
Solution
The printer has determined that the
installed ribbon has either jammed or
broken.
Open the printer cover and remove
the print ribbon. If ribbon is jammed,
remove the jam and tighten the
ribbon.
Clear any cards in the printer by
pressing the Forward and/or Back
buttons on the printer display.
Tape the ends of the ribbon together
and wind any excess onto the take-up
spool of the print ribbon.
Re-install the print ribbon, close the
printer cover and press Resume on
the printer display to continue
printing.
To cancel the print, press Cancel on
the printer display or click Cancel
Print from the HID Printer Status
Monitor.
Open the printer cover and remove
the print film. Check the film and see
if it is broken.
If the print film is not broken, re-install
the print film, close the printer cover,
and press Resume on the printer
display to continue printing.
If the print film is broken, tape the
ends of the print film together and
wind any excess onto the take-up
spool. Re-install the print film, close
the printer cover and press Resume
on the printer display to continue
printing.
To cancel the print, press Cancel on
the printer display or click Cancel
Print from the HID Printer Status
Monitor.
A non-SecureMark ribbon or film is
installed in a SecureMark printer.
Replace with the appropriate
SecureMark ribbon or film and press
Resume on the printer display to
continue printing.
Install a certified print ribbon and
press Resume on the printer display
to continue printing.
To cancel the print, press Cancel on
the printer display or click Cancel
Print from the HID Printer Status
Monitor.
115