HID FARGO HDP 6600 X002200 User Manual page 76

To change a setting, click the Edit Settings link. In the value column, change the numeric value in the row.
When all updates are correct, click the Save Settings link.
Setting
Head Resistance
Print Left Of Form
Image Darkness
Print Top of Form
76
Printing preferences
Description
This is factory set. If the main board or the printhead is replaced, then adjust this
number. Locate the printhead setting number on the bottom of the printhead. The
number reads: R=XXXX.
Prints the alignment self-test card.
Adjust the Print Left of Form up or down until the border of the left of form zero
line is showing on the edge of the card.
Measure the density square. Adjust the image density to 65% ± 1%.
Use this option to set the overall darkness of the printed image by increasing or
decreasing the amount of heat the printhead uses while printing.
Use the up and down arrows to increase or decrease the amount of heat.
Important: If the value is set too high, the ribbon may jam or break.
Print the alignment self-test card.
Adjust the Print Top of Form until the green border is eliminated and the entire
transfer alignment block is as shown in the bottom graphic
Note: Due to variation in roller alignment, the green border may appear at a slight
angle on the top of the card.
Edge of transfer
(green border)
Transfer alignment block
Image once adjusted
PLT-02931, Rev. A.0
September 2018