HID FARGO HDP 6600 X002200 User Manual page 111

PLT-02931, Rev. A.0
Printer Display Error Message
Reboot Required
Error Message No. 430
Remove Card
Error Message No. 464
Remove Ribbon
Error Message No. 533
Ribbon Break/Jam
Error Message No. 523, 537
Ribbon Low
Error Message No. 528
Check Ribbon
Error Message No. 530
Ribbon Out
Error Message No. 526, 538
Invalid Ribbon
Error Message No. 519, 531
Unable to Feed
Error Message No. 474
See Manual
Error Message No. 453
Waiting for Data
Error Message No. 454
Wrong Film
Error Message No. 494
September 2018
Cause
Unspecified system error detected
by the printer firmware.
A card is jammed in the print station
or card flipping area of the printer.
The print ribbon is installed and
needs to be removed.
The ribbon is not able to find the
next panel correctly. Check for
jams/breaks.
The ribbon will soon run out.
The ribbon is not able to find the
next panel correctly. Check for
jams/breaks.
The ribbon has run out.
The ribbon is not installed properly
or has been damaged.
The printer is unable to feed a card
from the card hopper.
Command resulted in an error.
The printer has stopped receiving
data from the PC.
The print film installed in the printer
does not match the film type
selected in the printer driver.
OR
A self-test job cannot be printed with
the print media installed.
Troubleshooting
Solution
Reset the printer and try again.
If this problem persists, call for
technical assistance.
Clear the jam and press Cancel.
Remove the ribbon.
If jammed, clear the jam. If broken,
repair the ribbon by taping the
ribbon back on to the take-up core.
Press Resume to continue or Cancel
to abort.
If printing a large number of cards,
replace the ribbon now or monitor
the printer until the ribbon is gone
and install a new ribbon.
If jammed, clear the jam. If broken,
repair by taping the ribbon back on
to the take-up core.
Press Resume to continue or Cancel
to abort.
Install a new ribbon and press
Resume to continue.
Verify the correct ribbon is installed
in the ribbon cartridge.
Verify there are cards in the card
cartridge.
Verify cards are not stuck together or
jammed, and they are the correct
thickness.
Verify correct utility command is sent
to the printer.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
Replace the film in the printer with
the type specified by the printer
driver.
A reboot is required.
111