Table of Contents
Advertisement
3
Status Registers
*ESE <integer> command where <integer> is the sum of
the decimal values of the bits you want to enable. For
example, to enable bit 7 and bit 6 so that whenever either of
those bits is set to 1, the standard event status summary bit
of the status byte register will be set to 1, send the
command *ESE 192 (128 + 64). The command *ESE?
returns the decimal value of the sum of the bits previously
enabled with the *ESE <integer> command.
The standard event status enable register presets to zeros
(0).
Figure 3
Standard Event Status Event Enable Register
30
N9340B Programmer's Guide
Advertisement
Table of Contents
