Tgenerator Subsystem - Agilent Technologies N9340B Programmer's Manual

5 Command Reference

TGENerator Subsystem

94
The TGENerator subsystem controls the use of the tracking
generator mode of the analyzer. Use the command
:INSTrument[:SELect] TGENerator to access this
subsystem.
Output Amplitdue
:TGENerator:AMPLitude <ampt>
:TGENerator:AMPLitude?
*RST:
–20 dBm
Range:
0 to –30 dBm
Key access: Meas > Amplitude
Amplitude On/Off
:TGENerator:AMPLitude:STATe OFF|ON|0|1
:TGENerator:AMPLitude:STATe?
This command toggles the state of tracking generator
between on and off.
*RST:
Off
Key access: Meas > Amplitude On Off
Amplitude Step
:TGENerator:AMPLitude:STEP <ampt>
:TGENerator:AMPLitude:STEP?
This command sets the amplitude step size of the tracking
generator output. This command is valid after tracking
generator is enabled.
*RST:
Off
Key access: Meas > Amptd Step
N9340B Programmer's Guide