Automatic Unlock Doors On Exit - Chrysler 300 2017 Owner's Manual

To Enter The Trunk
With a valid Passive Entry key fob within 5 ft
(1.5 m) of the deck lid, push the button on the
right side of CHMSL (Center High Mounted Stop
Light), which is located on the deck lid.
Trunk Passive Entry Button
NOTE:
If you inadvertently leave your vehicle's Passive
Entry key fob in the trunk and try to close the
deck lid, the deck lid will automatically unlatch,
unless another one of the vehicle's Passive
Entry key fobs is outside the vehicle and within
5 ft (1.5 m) of the deck lid.
To Lock The Vehicle's Doors
With one of the vehicle's Passive Entry key fobs
within 5 ft (1.5 m) of the driver or passenger front
door handles, push the door handle lock button
to lock all four doors.
30
Push The Door Handle Button To Lock
Do NOT grab the door handle when pushing the
door handle lock button. This could unlock the
door(s).
Do NOT Grab The Door Handle When Locking
NOTE:
• After pushing the door handle button, you
must wait two seconds before you can lock or
unlock the doors, using either Passive Entry
door handle. This is done to allow you to
check if the vehicle is locked by pulling the
door handle, without the vehicle reacting and
unlocking.
• The Passive Entry system will not operate if
the key fob battery is dead.
The vehicle doors can also be locked by using
the key fob lock button or the lock button located
on the vehicle's interior door panel.

Automatic Unlock Doors On Exit

The doors will unlock automatically on vehicles
with power door locks if:
1. The Automatic Unlock Doors On Exit feature
is enabled.
2. The vehicle was in motion, then speed re-
turned to 0 mph (0 km/h) and the transmis-
sion is placed in PARK.
3. The driver door is opened.
4. The doors were not previously unlocked.