Removing The Oil Pumps; Removing The Primary Gear; Removing The Iree Wheel Gear - KTM 400 EXC AUS 2011 Repair Manual

301DISASSEMBLING THE ENGINE
114
- Remove pi ns •.
- Remove screws •.
- Remove oil pump cover. of the force pumps.
- Remove oil pump shaft. of the gear oil force pump together with internal rotor . ,
external rotor. and pin •.
- Remove internal rotor. and external rotor. of the engine oil force pump.
- Remove the pin.
- Push oil pump shaft. inward and take it out of the engine from the ignition side.
- Plug the special tool into the crankshaft.
I
Protection cover (75029090000) (-- p. 259)
- Screw special tool
0
on to primary gear •.
I
Extractor (75029021000) (-- p. 257)
- Counteracting with the special tool, take off the primary gear by taking out the
screw.
- Remove the special tools.
- Remove spri ng washer •.
- Take off free-wheel gear •.
301DISASSEMBLING THE ENGINE
114
- Remove pi ns •.
- Remove screws •.
- Remove oil pump cover. of the force pumps.
- Remove oil pump shaft. of the gear oil force pump together with internal rotor . ,
external rotor. and pin •.
- Remove internal rotor. and external rotor. of the engine oil force pump.
- Remove the pin.
- Push oil pump shaft. inward and take it out of the engine from the ignition side.
- Plug the special tool into the crankshaft.
I
Protection cover (75029090000) (-- p. 259)
- Screw special tool
0
on to primary gear •.
I
Extractor (75029021000) (-- p. 257)
- Counteracting with the special tool, take off the primary gear by taking out the
screw.
- Remove the special tools.
- Remove spri ng washer •.
- Take off free-wheel gear •.