Removing The Carburetor; Installing The Carburetor - KTM 400 EXC AUS 2011 Repair Manual

31/CARBURETOR
RemDYinl tile carburetDr
- Direct the hose of the float chamber into a suitable container.
• Info
I
Water in the float chamber results in malfunctioning.
- Undo the screw
e
(turn it counterclockwise) a few turns and drain the fuel from
the float chamber.
- Tighten screw
e.
- Remove the fuel tank. (-- p. 66)
- Remove the carburetor connection boot. (-- p. 65)
- Remove screw
e.
Remove the carburetor cover.
- Push back bellows •.
- Undo nuts
e,
detach the cables and hang them to one side.
- Loosen hose clip •.
- Pull engine vent hose
e
off
of
the carburetor.
- Unplug the connector
e
of the throttle valve sensor.
- Unthread the carburetor vent hoses. Pull the carburetor out of the rubber sleeve
and remove it.
(EXC EU, EXC SIX DAYS)
- Twist out the choke slide and hang it to one side together with the cable.
(EXC EU, EXC SIX DAYS)
- Mount and tighten the choke slide.
Guideline
I
Choke sl ide
- Insert the carburetor into the rubber sleeve.
• Info
12.5
Nm
(1.84 Ibf
ftl
163
I
Align nose. on the carburetor with the notch in the rubber sleeve. The car-
buretor must be positioned vertically.
- Position the carburetor vent hoses.
- Attach connector of throttle valve sensor O.
31/CARBURETOR
RemDYinl tile carburetDr
- Direct the hose of the float chamber into a suitable container.
• Info
I
Water in the float chamber results in malfunctioning.
- Undo the screw
e
(turn it counterclockwise) a few turns and drain the fuel from
the float chamber.
- Tighten screw
e.
- Remove the fuel tank. (-- p. 66)
- Remove the carburetor connection boot. (-- p. 65)
- Remove screw
e.
Remove the carburetor cover.
- Push back bellows •.
- Undo nuts
e,
detach the cables and hang them to one side.
- Loosen hose clip •.
- Pull engine vent hose
e
off
of
the carburetor.
- Unplug the connector
e
of the throttle valve sensor.
- Unthread the carburetor vent hoses. Pull the carburetor out of the rubber sleeve
and remove it.
(EXC EU, EXC SIX DAYS)
- Twist out the choke slide and hang it to one side together with the cable.
(EXC EU, EXC SIX DAYS)
- Mount and tighten the choke slide.
Guideline
I
Choke sl ide
- Insert the carburetor into the rubber sleeve.
• Info
12.5
Nm
(1.84 Ibf
ftl
163
I
Align nose. on the carburetor with the notch in the rubber sleeve. The car-
buretor must be positioned vertically.
- Position the carburetor vent hoses.
- Attach connector of throttle valve sensor O.