Fork Offset (Xc-W Six Days) - KTM 400 EXC AUS 2011 Repair Manual

Ol/FORK, TRIPLE CLAMP
Forti offset (XC-W SIX DAYS)
- Tighten screw •.
Guideline
Screw, top steering stem M8
- Fully tighten screws •.
Guideline
Screw, top triple clamp M8
- Position the brake caliper. Mount and tighten screws •.
Guideline
Screw, front brake caliper M8
- Mount cable binder •.
25 Nm
(18.4 Ibf It)
20 Nm
(14.8 Ibf It)
20 Nm
(14.8 Ibf
It)
Loctite e 243""
- Position the brake line, wiring harness, and clamp. Mount and tighten
screws •.
- Install the front fender. ( ... p. 69)
- Refit the headlight mask with the headlight. ( ...
p. 69)
- Install the front wheel. ( ... p. 71)
33
- Check that the wiring harness, cables, and brake and clutch lines can move freely
and are routed correctly.
- Check the steering head bearing play. ( ... p. 34)
You can see the currently set offset if you remove
screw •.
The fork offset. has an impact on the handling of the vehicle. It is calculated from
the center of the fork leg to the center of the steering head bearing.
The fork offset can optionally be adjusted.
Marking
41
to the front gives greater stability on fast racetracks.
I
Fork offset
Front marking 118 mm (0.71 in)
Marking .. to the rear (condition at delivery) gives better handling in bends.
I
Fork offset
120 mm
(0.79
in)
Ol/FORK, TRIPLE CLAMP
Forti offset (XC-W SIX DAYS)
- Tighten screw •.
Guideline
Screw, top steering stem M8
- Fully tighten screws •.
Guideline
Screw, top triple clamp M8
- Position the brake caliper. Mount and tighten screws •.
Guideline
Screw, front brake caliper M8
- Mount cable binder •.
25 Nm
(18.4 Ibf It)
20 Nm
(14.8 Ibf It)
20 Nm
(14.8 Ibf
It)
Loctite e 243""
- Position the brake line, wiring harness, and clamp. Mount and tighten
screws •.
- Install the front fender. ( ... p. 69)
- Refit the headlight mask with the headlight. ( ...
p. 69)
- Install the front wheel. ( ... p. 71)
33
- Check that the wiring harness, cables, and brake and clutch lines can move freely
and are routed correctly.
- Check the steering head bearing play. ( ... p. 34)
You can see the currently set offset if you remove
screw •.
The fork offset. has an impact on the handling of the vehicle. It is calculated from
the center of the fork leg to the center of the steering head bearing.
The fork offset can optionally be adjusted.
Marking
41
to the front gives greater stability on fast racetracks.
I
Fork offset
Front marking 118 mm (0.71 in)
Marking .. to the rear (condition at delivery) gives better handling in bends.
I
Fork offset
120 mm
(0.79
in)