Installing The Oil Filte; Filling Up With Engine Oil - KTM 400 EXC AUS 2011 Repair Manual

381lUBRICATION SYSTEM
183
Fllllni UP. with Inllnl all
• Info
- Place a suitable container under the engine.
- Remove screws •. Remove oil filter cover. with the O-ring.
- Pull the oil filter insert. out of the oil filter casing.
1
Circlip pliers reverse (51012011000) (-- p. 255)
- Completely drain the engine oil.
- Thoroughly clean parts and sealing surface.
- Lay the motorcycle on its side and fill the oil filter housing to about 11, full with
engine oil.
- Fill the oil filter
0
with engine oil and place it in the oil filter container.
- Lubricate the Olring • of the oil filter cover.
- Refit the oi I fi Iter cover •.
- Mount and tighten screws •.
Guideline
1
Screw, oil filter cover
110
Nm (7.4 Ibf ft)
1
- Stand the motorcycle upright.
I
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
- Remove the screw cap. on the alternator cover and fill up with engine oil.
Engine oil (lst
0.35 I (0.37 qt.) Engine oil (SAE lOW/50) (-- p. 250)
partial quantity
approx.)
- Mount and tighten the screw connection on the alternator cover.
. . . Danger
t.,;,J
Dangar 01 poisoning
Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
- When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
381lUBRICATION SYSTEM
183
Fllllni UP. with Inllnl all
• Info
- Place a suitable container under the engine.
- Remove screws •. Remove oil filter cover. with the O-ring.
- Pull the oil filter insert. out of the oil filter casing.
1
Circlip pliers reverse (51012011000) (-- p. 255)
- Completely drain the engine oil.
- Thoroughly clean parts and sealing surface.
- Lay the motorcycle on its side and fill the oil filter housing to about 11, full with
engine oil.
- Fill the oil filter
0
with engine oil and place it in the oil filter container.
- Lubricate the Olring • of the oil filter cover.
- Refit the oi I fi Iter cover •.
- Mount and tighten screws •.
Guideline
1
Screw, oil filter cover
110
Nm (7.4 Ibf ft)
1
- Stand the motorcycle upright.
I
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
- Remove the screw cap. on the alternator cover and fill up with engine oil.
Engine oil (lst
0.35 I (0.37 qt.) Engine oil (SAE lOW/50) (-- p. 250)
partial quantity
approx.)
- Mount and tighten the screw connection on the alternator cover.
. . . Danger
t.,;,J
Dangar 01 poisoning
Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
- When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.