Positioning The Fork Protector; Removing The Fork Legs; Inslalling Fork Legs - KTM 400 EXC AUS 2011 Repair Manual

Ol/FORK, TRIPLE CLAMP
Installinl
fortll8P-
14
- Position the fork protector on the left fork leg. Mount and tighten screws O.
Guideline
I
Remaining screws, chassis 110
Nm (7.4 Ibf
ft)
I
- Position the brake line and wiring harness. Put the clamp on, and mount and
tighten screws •.
- Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
I
Remaining screws, chassis
110
Nm (7.4 Ibf
ft)
I
- Remove front wheel. (-- p.
71)
- Remove screws. and remove the clamp.
- Remove cable clip . , remove screw. and remove the brake caliper.
- Allow the brake caliper and brake line to hang tension-free to the side.
(EXC USA,
all
SIX DAYS
models)
- Unscrew screws •. Take out the left fork leg.
- Unscrew screws •. Take out the right fork leg.
(EXC EUiAUS)
- Unscrew screws •. Take out the left fork leg.
- Unscrew screws •. Take out the right fork leg.
- Position the fork legs.
• Info
I
The topmost milled groove in the fork leg must be flush to the upper edge of
the upper triple clamp.
Position bleeder screws. toward the front.
Ol/FORK, TRIPLE CLAMP
Installinl
fortll8P-
14
- Position the fork protector on the left fork leg. Mount and tighten screws O.
Guideline
I
Remaining screws, chassis 110
Nm (7.4 Ibf
ft)
I
- Position the brake line and wiring harness. Put the clamp on, and mount and
tighten screws •.
- Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
I
Remaining screws, chassis
110
Nm (7.4 Ibf
ft)
I
- Remove front wheel. (-- p.
71)
- Remove screws. and remove the clamp.
- Remove cable clip . , remove screw. and remove the brake caliper.
- Allow the brake caliper and brake line to hang tension-free to the side.
(EXC USA,
all
SIX DAYS
models)
- Unscrew screws •. Take out the left fork leg.
- Unscrew screws •. Take out the right fork leg.
(EXC EUiAUS)
- Unscrew screws •. Take out the left fork leg.
- Unscrew screws •. Take out the right fork leg.
- Position the fork legs.
• Info
I
The topmost milled groove in the fork leg must be flush to the upper edge of
the upper triple clamp.
Position bleeder screws. toward the front.