09/Front Wheel; Removi Ng Front Wheel - KTM 400 EXC AUS 2011 Repair Manual

O9IFRONT WHEEL
RemDYin& front wheel
Warning
- Raise the motorcycle with the lift stand. (or p.
10)
- Press the brake caliper by hand on to the brake disc in order to press back the
brake pistons.
• Info
I
Make sure when pushing back the brake pistons that you do not press the
brake caliper against the spokes.
- Remove screw •.
- Loosen screw •.
- Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
• Info
I
00
not operate the hand brake lever when the front wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
- Remove spacers •.
Danler of accidents Reduced braking efficiency due to oil or grease on the brake discs.
- Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
- Check the wheel bearing for damage and wear.
>
If the wheel bearing is damaged or worn:
- Change the wheel bearing.
- Clean and grease shaft seal rings. and bearing surface. of the spacers.
I
Long-life grease
('r
p. 252)
- I nsert the spacers.
71
O9IFRONT WHEEL
RemDYin& front wheel
Warning
- Raise the motorcycle with the lift stand. (or p.
10)
- Press the brake caliper by hand on to the brake disc in order to press back the
brake pistons.
• Info
I
Make sure when pushing back the brake pistons that you do not press the
brake caliper against the spokes.
- Remove screw •.
- Loosen screw •.
- Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
• Info
I
00
not operate the hand brake lever when the front wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
- Remove spacers •.
Danler of accidents Reduced braking efficiency due to oil or grease on the brake discs.
- Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
- Check the wheel bearing for damage and wear.
>
If the wheel bearing is damaged or worn:
- Change the wheel bearing.
- Clean and grease shaft seal rings. and bearing surface. of the spacers.
I
Long-life grease
('r
p. 252)
- I nsert the spacers.
71