KTM 400 EXC AUS 2011 Repair Manual page 53

04LSHOCK ABSORBER, SWINGARM
53
- Mount rebound damping washer •.
- Mount compression damping shim stack. with the smaller shims facing down-
ward.
- Grind piston. on both sides, using 1200 grit sandpaper on a surfacing plate.
- Clean the piston.
- Mount the piston.
Guideline
View. Top view of piston
View. Bottom view of piston
200768-10
- Mount rebound damping shim stack. with the smaller shims at the top.
- Apply thread locker to the threads of the piston rod.
I
Loclil'" 2701
- Screw on mount. to the point where the piston can still be turned.
- Mount compression damping shim stack. with the smaller shims at the bottom.
200770-10
- Grind piston. on both sides on a surface plate using 1200 grit sandpaper.
- Clean the piston.
- Mount the piston.
Guideline
View. Top view of piston
View. Bottom view of piston
- Mount rebound damping shim stack. with the smaller shims facing upward.
- Grease the threads of the mount.
I
Lubricant (T152)
(or
p. 253)
- Mou nt nut. but do not tighten yet.
04LSHOCK ABSORBER, SWINGARM
53
- Mount rebound damping washer •.
- Mount compression damping shim stack. with the smaller shims facing down-
ward.
- Grind piston. on both sides, using 1200 grit sandpaper on a surfacing plate.
- Clean the piston.
- Mount the piston.
Guideline
View. Top view of piston
View. Bottom view of piston
200768-10
- Mount rebound damping shim stack. with the smaller shims at the top.
- Apply thread locker to the threads of the piston rod.
I
Loclil'" 2701
- Screw on mount. to the point where the piston can still be turned.
- Mount compression damping shim stack. with the smaller shims at the bottom.
200770-10
- Grind piston. on both sides on a surface plate using 1200 grit sandpaper.
- Clean the piston.
- Mount the piston.
Guideline
View. Top view of piston
View. Bottom view of piston
- Mount rebound damping shim stack. with the smaller shims facing upward.
- Grease the threads of the mount.
I
Lubricant (T152)
(or
p. 253)
- Mou nt nut. but do not tighten yet.