Commissioning; General Rules For Manipulation Of The Spray Gun; Preparation For Starting Up - WAGNER GM 5000EAC F Operating Manual

EDITION 07/2014
OPERATING MANUAL
6.6

COMMISSIONING

6.6.1

GENERAL RULES FOR MANIPULATION OF THE SPRAY GUN

Observe safety instructions in Chapter 4.
High-voltage fi eld!
Danger to life from malfunction of heart pacemakers.
Make sure that persons with pace makers:
Unintentional putting into operation!
Risk of injury.
Before any work on the device, in the event of work interruptions
and malfunctions:
6.6.2

PREPARATION FOR STARTING UP

The following points should be noted before commissioning
Grounding see Chapter 6.4.5. Make sure that all other conductive parts within the
work area are grounded.
Connect the product hose to spray gun and product pump.
Check that all product-conveying connections are correctly connected
Connect air hose to spray gun and to supply of oil-free dry air, approx. 0.25 MPa;
2.5 bar; 36 psi. Compressed air quality class 3.5.2 according to ISO 8573.1.
Check that all air-conveying connections are correctly connected.
Connect the electric cable to the spray gun and to the VM 5000 or VM 500 control
unit.
Visually check the permissible pressures for all the system components.
Check the level of the separating agent in the Wagner pneumatic pump and fi ll the
separating agent up if necessary.
ORDER NUMBER DOC 2344500
DANGER
Do not work with the electrostatic spray gun.
Stay outside the area of the electrostatic spray gun/work piece.
WARNING
Switch off the energy/compressed air supply.
Relieve the pressure from the spray gun and unit.
Secure the spray gun against actuation.
In the event of functional faults: remedy the fault as described
in the "Troubleshooting" chapter.
34