Transportation; Moving; Transport Using A Crane (Fig. 4); Transportation In Vehicle - WAGNER PLAST COAT HP 30 Operating Manual

EN
TRANSPORTATION / COMMISSIONING
5

TRANSPORTATION

5.1

MOVING

Wind power cable around handle and remove the hose.
Put away the nozzles and other small objects in the storage
compartment.
Push or pull the PC HP 30 by the handle.
Appliance weighs over 70 kg. Only lift or
carry the appliance with at least 3 people.
5.2

TRANSPORT USING A CRANE (FIG. 4)

For attaching points for the straps or rope (not wire cable) see
figure.

5.3

TRANSPORTATION IN VEHICLE

Secure the unit in the vehicle by means of suitable fasteners.
To avoid material residues leaking from the
machine, clean the device in advance or lock
the mortar connection. Do not fill the contain-
er completely full in order to prevent material
from splashing out of it.
32
6

COMMISSIONING

6.1

INSTALLATION LOCATION

Ideally only place the machine on flat surfaces in order to stop
it from sliding away.
6.1.1
CONNECTION TO MAINS POWER SUPPLY/
EXTENSION CABLE
Connection to the mains network only via a special feed-
ing point, for example via a distribution board for con-
struction sites, with residual current protective device
with INF ≤ 30 mA.
Lay the device supply cable so that there is no
danger of stumbling.
Protect against damage, for example against
being driven over.
Min. wire cross-section 3 x 2.5 mm
extension cable completely. Ensure that the
coupling pieces and plugs are free of damage.
• Before connecting the unit to the mains supply, ensure that
the line voltage matches that specified on the rating plate.
6.2

INITIAL STARTING-UP

6.2.1

SCOPE OF SUPPLY

The machine is supplied by the manufacturer in the following
individual components:
• Complete basic machine comprising drive unit, control unit,
receptacle and transport frame with wheels
• Hose package (incl. hose whip)
• Spray gun
• Pump sliding means
• Toolbag with nozzles, cleaning accessories, double open
ended spanner,...
6.3

PREPARING THE MACHINE

At delivery, the pump unit is filled with con-
servation agent (PlastGuard longlasting, Art.
No. 2399 960). At initial commissioning and
with each subsequent use of this conservati-
on agent, it should first be pumped fully out
before work commences.
Do not use any water during commission-
ing to flush the conservation agent out.
Doing so could cause the rotor and stator
to seize, requiring them to be replaced.
• Place a flat trough under the hose connection.
• Check that the pump unit is seated firmly.
Plast Coat HP 30
. Unroll the
2