Functioning Of The Spray Gun - WAGNER GM 5000EAC F Operating Manual

EDITION 07/2014
OPERATING MANUAL
5.1.2

FUNCTIONING OF THE SPRAY GUN

When the spray gun is connected to the control unit and the
control unit is switched on, the pre-defi ned recipe (R1, R2 or
R3) is shown on the gun display (2) as follows.
Recipe 1 ->
Recipe 2 ->
Recipe 3 ->
Recipe change R1 -> R2 -> R3 -> R1.
Press the operating button (4) and keep the button pressed
of at least 2 seconds, then it is advanced by 1 recipe.
Display (2) ->
The stored recipe values of the previously selected recipe number
are re-loaded from memory by pressing the operating button (4)
for 2 seconds.
During spraying (trigger lever pressed), the status is shown in the display (2) by LEDs.
LED display
LEDs 1 - 3 light up green
one or both right-hand LEDs light up
orange
(Warning display: You can continue
working without any limitations.)
ORDER NUMBER DOC 2344500
= recipe values changed temporarily:
Description
The spray gun is working in an optimal
high-voltage spray current range
spray current too high
Possible causes:
2
Spray gun too close to the work piece
Contamination of the spray gun
Paint conductivity too high
R2
3
4
B_03182
20