Spray Process - WAGNER GM 5000EAC F Operating Manual

EDITION 07/2014
OPERATING MANUAL
5.4

SPRAY PROCESS

5.4.1
AIRCOAT ROUND JET SPRAY PROCESS
In the AirCoat process, the spray product is atomized under a pressure of 3-15 MPa; 30-150 bar; 435-2,176 psi.
With the help of an air pressure of 0-0.25 MPa; 0-2.5 bar; 0-36 psi, a soft, spray jet is produced. The spray jet
diameter can be adjusted by turning the nozzle nut.
Advantages
Large application volume
Low fogging tendency
Good fi nish
High viscosity paints can easily be applied
High endurance of the nozzles
Jet width adjustment
5.4.2
AIRCOAT FLAT JET SPRAY PROCESS
In the AirCoat process, the spray product is atomized under a pressure of 3-15 MPa; 30-150 bar; 435-2,176 psi.
With the help of the AirCoat air, with a pressure of 0-0.25 MPa; 0-2.5 bar; 0-36 psi, a soft, fl at spray jet is produced
which largely eliminates the problem of overlapping in the peripheral zones. With shaping air, there is the
possibility of reducing the width of the spray jet.
Advantages
Large application volume
Low fogging tendency
Good fi nish
High viscosity paints can easily be applied
High endurance of the AC-nozzles
Jet width adjustment
ORDER NUMBER DOC 2344500
AirCoat air
Spray product
AirCoat air
Variable spray jet
width
Nozzle nut
Multi-channel
swirl nozzle
Shaping air
Atomizing air
Spray jet
Aircap
B_00020
24