Disassembly Of The Spray Gun; Tools - WAGNER GM 5000EAC F Operating Manual

EDITION 07/2014
OPERATING MANUAL
Incorrect maintenance/repair!
Danger to life and equipment damage.
8.3

DISASSEMBLY OF THE SPRAY GUN

8.3.1

TOOLS

For disassembling and assembling the gun the following tools are required:
Allen wrench SW 2
Allen wrench SW 3
Allen wrench SW 5
Open-end wrench SW 5
Open-end wrench SW 6
Open-end wrench SW 8
Open-end wrench SW 11
Open-end wrench SW 12
Open-end wrench SW 14
Open-end wrench SW 19
Open-end wrench SW 21
Open-end wrench SW 22
Ring spanner SW 9
Torx wrench 20
Torx wrench 25
Assembly tool valve needle Order No. 2309368
Assembly tool clamping screw Order No. 2325263
ORDER NUMBER DOC 2344500
DANGER
Only a WAGNER service center or a suitably trained person may
carry out repairs and replace parts.
Only repair and replace parts that are listed in the "Spare Parts"
chapter and that are assigned to the device.
Before all work on the device and in the event of work
interruptions:
- Disconnect the control unit from the mains.
- Relieve the pressure from the spray gun and device.
- Secure the spray gun against actuation.
Observe the operating manual and service instructions at all
times when carrying out work.
49