Correct Use - WAGNER GM 5000EAC F Operating Manual

EDITION 07/2014
OPERATING MANUAL
2

CORRECT USE

2.1
DEVICE TYPE
Electrostatic manual spray gun for manual coating of grounded work pieces
2.2
CORRECT USE
The GM 5000EAC electrostatic hand spray gun is suitable for spraying liquid products,
particularly coating products, using the AirCoat method. Coating products containing
solvents of explosion class II A may be used.
2.3
USE IN AN EXPLOSION HAZARD AREA
The GM 5000EAC electrostatic manual spray gun is suitable for coating electrically
conductive objects with liquid coating products and can be used in potentially explosive
areas. (See Chapter 3 "Identifi cation".)
2.4
SAFETY PARAMETERS
The GM 5000EAC electrostatic manual spray gun is only suitable for spraying liquid
products, particularly coating products.
J. Wagner AG forbids any other use!
The electrostatic manual spray gun may only be operated under the following conditions:
the operating staff have previously been trained on the basis of this operating manual,
the safety regulations listed in this operating manual are observed,
the operating, maintenance and repair information in this operating manual is
observed,
and the statutory requirements and accident prevention regulations standards in the
country of use are observed.
The electrostatic manual spray gun may only be operated if all parameters are set and all
measurements/safety checks are carried out correctly.
ORDER NUMBER DOC 2344500
8