Detaching A D1X Or D1Xl Series Header - MacDon M1170 Operator's Manual

Hide thumbs Also See for M1170:

Table of Contents

11. Retrieve knife and reel drive multicoupler (A) from hose

management arm.

12. Push knob (B) on hydraulic receptacle and pull handle (C)

fully away from windrower.

13. Open cover (D) and position coupler onto receptacle. Align

pins in coupler with slots in handle (C) and push handle

toward windrower so that coupler is locked onto receptacle

and knob (B) snaps out.

14. Close platform. Refer to

15. Ensure hydraulic hose routing is as straight as possible and

avoids potential rub/wear points.

Detaching a D1X or D1XL Series Header

To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key

from the ignition before leaving the operator's seat for any reason.

1. Lower the reel fully.

2. Lift the header fully.

3. Stop the engine and remove the key from the ignition.

5.4.2 Closing Platform, page

Figure 4.114: Knife/Reel Drive Multicoupler

Figure 4.115: Hydraulic Multicouplers and Hose