MacDon M1170 Operator's Manual page 38

MD #166457
General hazard pertaining to machine operation and servicing
CAUTION
To avoid injury or death from improper or unsafe machine
operation:
• Read the operator's manual and follow all safety
instructions.
• Do NOT allow untrained persons to operate the machine.
• Review safety instructions with all Operators every year.
• Ensure that all safety signs are installed and legible.
• Make certain everyone is clear of machine before starting
engine and during operation.
• Keep riders off the machine.
• Keep all shields in place and stay clear of moving parts.
• Disengage header drive, put transmission in Neutral and
wait for all movement to stop before leaving operator's
position.
• Stop the engine and remove the key from the ignition
before servicing, adjusting, lubricating, cleaning, or
unplugging machine.
• Engage locks to prevent lowering of header or reel before
servicing in the raised position.
• Use slow moving vehicle emblem and flashing warning lights
when operating on roadways unless prohibited by law.
Run-over hazard
WARNING
• Machine will move if steering wheel is turned while engine is
running.
• Steering response is opposite to what is normally expected
when backing up. Turn bottom of steering wheel in direction
you want to go.
• Always move ground speed lever to slow end of range before
shifting high-low speed control.
• Stop the engine and remove the key from the ignition before
servicing, adjusting, lubricating, cleaning, or unplugging the
machine.
214733
SAFETY
Figure 1.37: MD #166457
22
Revision A