Drive Wheels; Raising Drive Wheel - MacDon M1170 Operator's Manual

6. Examine fuse (A) for indications of melting.
7. To remove fuse (A), remove two nuts (B) and pull the fuse
free from holder (existing wiring may need to be pulled off
the stud first).
8. Install the new fuse on studs and install any existing wiring
that was removed.
9. Secure with nuts (B).
10. Close cover (B) and secure with tab (A).
11. Return platform to operating position. Refer to
Closing Platform, page

5.15.8 Drive Wheels

Raising Drive Wheel

This procedure applies to both drive wheels.
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
CAUTION
Header MUST be removed and NO weight box installed. Use a hydraulic jack with minimum lifting capacity of 2268 kg
(5000 lb.) to provide adequate support for the machine.
1. Disconnect the header.
2. Park windrower on level ground. Block all wheels.
214733
MAINTENANCE AND SERVICING
5.4.2
258.
A
Figure 5.207: 125A Main Fuse
Figure 5.208: 125A Main Fuse
387
B B
B
A
Revision A