MacDon M1170 Operator's Manual page 156

Preparing Windrower to Tow a Header
1. Attach header to windrower. Refer to
D1XL Series Header, page
2. Convert header to transport mode. Refer to header
operator's manual.
3. Detach header from windrower. Refer to
or D1XL Series Header, page
4. Remove hairpin (D) and clevis pin (C) securing header
support (B) to leg (A). Retain pins for attaching weight box.
5. Remove header support (B) from windrower lift leg (A).
6. Repeat above step for opposite support.
7. Drive windrower so that lift legs (A) are positioned into the
weight box (B) pockets. Raise lift legs slightly.
8. Stop the engine and remove the key.
9. Install locking pin (C) into pocket and secure with
hairpin (D). Repeat for opposite leg.
NOTE:
Pins were previously removed from the header supports.
214733
OPERATION
Attaching a D1X or
158.
Detaching a D1X
165.
Figure 4.55: Windrower with Header
D
C
Figure 4.56: Draper Header Support
A
Figure 4.57: Windrower Lift Linkage
140
A
B
B
D
C
Revision A