Checking Engine Oil Level - MacDon M1170 Operator's Manual

5.7.1 Checking Engine Oil Level

Check engine oil level frequently and watch for any signs of leakage.
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
NOTE:
During the break-in period, a higher than usual oil consumption should be considered normal.
NOTE:
Oil can be checked without opening the hood.
1. Operate the engine at low idle and check for leaks at the filter and drain plug.
2. Stop the engine and remove the key. Wait about five minutes.
3. Remove dipstick (A) by turning it counterclockwise to
unlock.
4. Wipe dipstick clean and reinsert it into engine.
5. Remove dipstick again and check oil level. Oil level should
be between LOW (L) and HIGH (H). If below the LOW mark,
add oil.
NOTE:
Adding 1.9 liters (2 US quarts) will raise the level from LOW
to HIGH. To add oil, refer to
6. Replace dipstick and turn it clockwise to lock.
214733
MAINTENANCE AND SERVICING
Adding Engine Oil, page 288.
Figure 5.50: Dipstick Location
Figure 5.51: Engine Oil Level
287
A
Revision A