D1X Or D1Xl Series Draper Header; Attaching Draper Header Supports - MacDon M1240 Unloading And Assembly Instructions

5.2 D1X or D1XL Series Draper Header

This section details the procedures necessary to physically attach a D1X or D1XL header to a windrower and to attach its
hydraulic and electrical connections. The procedures may vary slightly depending on the configuration of the windrower.

5.2.1 Attaching Draper Header Supports

Draper header supports are required to attach a D1X or D1XL Series Draper Header to the windrower.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
If not installed, attach the draper header support (supplied with the header) to the windrower lift linkage as follows:
1. Shut down the engine, and remove the key from the ignition.
2. Remove the hairpin from clevis pin (B) on draper header
support (A). Remove clevis pin (B).
3. Position draper header support (B) on windrower lift
linkage (A). Reinstall clevis pin (C).
NOTE:
To ensure that the pin doesn't snag the windrow, install the
clevis pin on the outboard side of the draper header
support.
4. Secure clevis pin (C) with hairpin (D).
5. Repeat Steps 2, page 84
remaining draper header support.
215627
ATTACHING HEADERS TO WINDROWER
to 4, page 84 to install the
Figure 5.25: Draper Header Support
Figure 5.26: Draper Header Support
84
Revision A