MacDon M1170 Operator's Manual page 387

6. Remove four machine screws (A) and nylon nuts (B) and
retain hardware.
7. Remove old headlight from bracket and replace with new
headlight.
IMPORTANT:
Do NOT touch the glass of the halogen bulb as oils or other
chemicals from your skin will cause the bulb to fail
prematurely.
8. Attach headlight to bracket using four retained machine
screws (A) and nylon nuts (B). Torque screws to 2.0–2.7 Nm
(18–24 lbf·in).
9. Connect wiring harness connector to headlight.
10. Attach headlight bracket assembly (B) using retained
bolts (A).
11. Align new headlight. Refer to
Forward, page 364.
12. Attach electrical connectors to red tail lights (C).
13. Attach headlight bezel assembly (B) to frame using the
eight retained hex flange bolts (A). Torque bolts to
2.0–2.7 Nm (18–24 lbf·in).
214733
MAINTENANCE AND SERVICING
Aligning Headlights: Engine-
B
Figure 5.180: Right Side Headlight Shown – Left Side
Similar
A A
Figure 5.181: Right Side Headlight Shown – Left Side
Similar
A A
C
Figure 5.182: Headlight Bezel Assembly
371
B
A A
B
A A A A
A
C
A A
Revision A