MacDon M1170 Operator's Manual page 133

9. Turn the IGNITION switch to crank (A).
NOTE:
When the engine starts and the header is not engaged, the
HPT will display the header disengaged screen (B).
IMPORTANT:
• Do NOT operate starter for longer than 15 seconds at
a time.
• If engine does not start, wait at least 2 minutes before
trying again.
• If you crank the engine for more than 30 seconds within
a 2-minute period, the engine will lock the starter circuit
to prevent overheating, and a flashing WTS symbol will
illuminate on the HPT display. Wait for the WTS symbol
to stop flashing before attempting to crank
engine again.
NOTE:
When engine temperature is below 5°C (40°F), the engine
will cycle through a period where it appears to labor until it
warms up. Do NOT operate engine above 1500 rpm until the
HPT engine temperature gauge is above the blue range (A).
214733
OPERATION
Figure 4.15: HPT Header Disengaged Screen
Figure 4.16: HPT No Header Screen
117
A
B
A
1019655
Revision A