Allen-Bradley ControlLogix System 1756-L1 User Manual page 228

13-6 Communicate with a PanelView
Publication 1756-UM001E-EN-P - August 2002
™ ™
Terminal Over a ControlNet Network
G. Click Next.
I.
J.
H. Type the rate that you want scheduled data to transfer with the
PanelView terminal.
• Use a power of two time the ControlNet NUT.
• For example, if the NUT is 5ms, type a rate of 10, 20ms, etc.
I. Initially, do you want the module to communicate with the
controller?
If:
Yes
No
J. If communication with the modules fails, how do you want the
controller to respond?
If you want the
controller to:
fault (major fault)
continue operating
K. Click Finish.
Your controller organizer should look similar to the following:
H.
Then:
Leave the check box cleared
(unchecked).
Select the check box.
Then:
Select the check box.
Leave the check box
cleared (unchecked).
42401
Notes:
When you test this portion of the
system, clear the check box.
Notes:
Monitor the connection
using ladder logic.
42402