Allen-Bradley ControlLogix System 1756-L1 User Manual page 211

H.
I.
Allen-Bradley HMIs
Communicate with Another Controller over a ControlNet
F. Click Next.
G. Initially, do you want the module to communicate with the
controller?
If:
Yes
No
Inhibit a module
EXAMPLE
To make it easier to test a system one module
or section at a time:
1. Initially, inhibit all the modules.
2. To test a section of the system, clear the
H. If communication fails, how do you want the controller to
respond?
If communication with a modules fails, the
ATTENTION
controller operates on old data from the
!
module. To avoid potential injury or damage,
either monitor communications with modules
or configure modules to produce a major fault
if communications fail.
If you want the
controller to:
fault (major fault)
continue operating
I. Click Finish.
Then:
Leave the check box cleared (unchecked).
Select the check box.
check boxes for the modules of that section
(i.e., uninhibit the modules).
Then:
Select the check box.
Leave the check box
cleared (unchecked).
Publication 1756-UM001E-EN-P - August 2002
™
Network 11-11
42398
Notes:
Monitor the connection
using ladder logic.