Allen-Bradley ControlLogix System 1756-L1 User Manual page 131

Allen-Bradley HMIs
Communicate with an RSView Project over an EtherNet/IP Network
H. Click the Data Collection tab.
I. Specify the following parameters:
For this item:
Processor Type
Data Collection Mode
J. Click the Advanced Communication tab.
K. Specify the following parameters:
For this item:
Communication Driver
Station
Local or Remote Addressing
L. In the Remote Routing Configuration dialog box, specify the
following parameters:
For this parameter:
Bridge Device
Local ID
Local KA5
Remote ID
M. Click OK.
N. Click Done and confirm the update of the topic.
Do this:
PLC-5
Select .
Polled Messages
1. Clear the
Unsolicited Messages
2. Select the
box.
Type or select:
driver for the network across which you will
send the message
slot number of the controller that is sending the
message
Remote
Type or select:
1785-KA5 Bridge/5130-KA
Virtual Link ID from Step D.
arbitrary number between 1 and 107 (RSLinx requires
an entry but this configuration does not use the entry.)
number that designates the backplane of the
ControlLogix chassis (Use a different number for each
backplane.)
Publication 1756-UM001E-EN-P - August 2002
7-15
check box.
check