Satec System 295 Installation And Operation Manual page 55

To enter a sub-menu:
Ä From the upper window, select the sub-menu entry with the up/down arrow
keys.
Ä Press
SELECT
sub-menus, see the paragraphs below.
To quit the secondary menu and return to the primary menu:
Ä Press
SELECT
Ä Press
to return to the primary menu .
ENTER
Viewing and Changing a Setpoint Condition
Each condition sub-menu displays the setup parameters for one of four setpoint
triggers. For information on specifying setpoint triggers, refer to Section 4.17.3. To
enter a sub-menu, choose one of the entries
using the up/down arrow keys, then press
the sub-menu windows:
Cnd1 Cnd1
ConJ GrP
Or rt.Hi
Conjunction Trigger
operation parameter
(Or/And) group
To view the trigger parameters:
Ä From the central window, scroll through the list of parameters with the up/down
arrow keys. The lower window will display the current parameter setup.
All trigger parameters that can be used for setpoint operation are organized in
groups that are listed in Table B-6 (see Appendix B) with the corresponding group
label. The trigger parameter is defined by both the parameter group and parameter
Operating The PM295
to enter the selected sub-menu . For instructions on operating
to choose the upper window.
Cnd1
InP
cur
Trigger
parameter
name
to
Cnd1 Cnd4
. The following illustrations show
SELECT
Cnd1 Cnd1
Cond On
GE 3000
Operate Operate
condition limit
(GE/LE
Eq/nE
On/OFF
nEU)
in the upper window
Cnd1
OFF
2950
Release
limit
47