Table of Contents
Advertisement
3.3.13 Pulsing Relay Setup
Select the
PulS
entry from the
The
PULSING RELAY SETUP
of 4 relay outputs. The upper window lists sub-menus for relay outputs, the central
window lists available outputs for the selected relay, and the lower window displays
the pulsing value in units per hour for the energy pulsing parameter. Available
outputs for pulse relay are listed in Table B-5 (see Appendix B) with the
corresponding window labels. See Section 4.9 for information on relay output
operation.
To select a relay output setup:
rEL.1
Ä From the upper window, select the desired relay with the
Ac.Ei
To change the output parameter for the relay:
0
Ä Press
Ä Scroll through the list of outputs with the up/down arrow
To change the number of unit-hours for energy pulses:
Ä Press
to choose the lower window.
SELECT
Ä Adjust the amount of unit-hours per pulse with the up/down arrow keys. The
available range is 1-9999.
To enter the changes made into setup:
Ä Press
ENTER to
To quit the menu:
Ä From the upper window, press
TROUBLESHOOTING
If your setup for the energy pulse output is not accepted by the instrument, check
whether you specified the amount of unit-hours per pulse.
44
MAIN
menu and press
menu consists of 4 sub-menus, each meant for one
up/down arrow keys.
to choose the central window.
SELECT
keys until the desirable output label appears.
return to the upper window.
ENTER
ENTER
.
to return to the
MAIN
Operating The PM295
menu.
Advertisement
Table of Contents
