Analog Expander Setup - Satec System 295 Installation And Operation Manual

Ä In the same way, select the
new group has been selected, a list of output parameters starts from the first
parameter in the group.
To adjust the scales for the analog output channel:
Ä In the central window, select the
Ä Press
SELECT
Ä Adjust the output zero scale with the up/down arrow keys.
Ä Press
ENTER to return to the central window.
Ä In the same way, select the
To quit the current channel setup:
Ä From the central window, press
To quit the menu:
Ä From the upper window, press
TROUBLESHOOTING
1. If your setup for either scale isn' t accepted by the instrument, check whether
the low scale value does not exceed the parameter full scale.
2. The output scales for the signed power factor are set permanently in the
instrument and may not be changed via the front panel.
NOTE
Each time you change the output parameter for the analog channel, its zero and
full scales are set by default to the lower and upper parameter limits, respectively.
If you want to restore the scales for any output to their default values, just change
and restore the output parameter.

3.3.12 Analog Expander Setup

Select the AEPn entry from the
The
ANALOG EXPANDER SETUP
channels. The menu operates in the same way as the
menu operates (see Section 3.3.11 above). Refer to Section 4.11 for information on
analog expander operation.
Operating The PM295
entry and choose the output parameter. After the
Out
Lo
to choose the lower window.
entry and adjust the output full scale.
Hi
ENTER
ENTER
MAIN menu and press
menu has 14 sub-menus for 14 extended analog
entry with the up/down arrow keys.
to return to the upper window.
to return to the MAIN
ENTER
ANALOG OUTPUT SETUP
menu.
.
43