Satec System 295 Installation And Operation Manual page 131

Table A-1 Displayed Parameters
Page/ Window
sub-page
5/2 6
5/2 8
5/2 9
5/3 1
5/3 2
5/3 3
5/3 4
5/4 1
5/4 2
5/4 3
6/1-8 3, 6, 9
NOTES
À
Display readings for all electrical quantities except demands and real-time harmonic parameters (pages
2 and 4) are sliding average values.
Á
Voltage and current readings with a decimal point are displayed in kV, kA. Auxiliary current readings
with a decimal point are displayed in amperes. Power readings with a decimal point are displayed in
MW, Mvar, MVA. The short range energy readings (page 3) with a decimal point are displayed in MWh,
Mvarh, MVAh. When the value width is over the window resolution, the right-most digits of the reading
will be truncated.
Â
The maximum range for short energy readings displayed on page 3 is 9,999 MWh/Mvarh/MVAh.
Beyond this value the reading rolls over to zero, and the corresponding display window will flash until the
user presses any key.
Ã
Date format can be customized.
Appendix A Display Formats
Range,
digits
4 Status input #6 (0/1)
5 Status input #7 (0/1)
5 Status input #8 (0/1)
3 Relay #1 status (0/1)
3 Relay #2 status (0/1)
3 Relay #3 status (0/1)
4 Relay #4 status (0/1)
3 Phase L1 angle
3 Phase L2 angle
3 Phase L3 angle
9 Counter #1-#8
Parameter À Unit Á
degrees
degrees
degrees
123