Table of Contents
Advertisement
LIMITED WARRANTY
The manufacturer offers the customer an 24-month functional warranty on the instrument
for faulty workmanship or parts from date of dispatch from the distributor. In all cases,
this warranty is valid for 36 months from the date of production. This warranty is on a
return to factory basis.
The manufacturer does not accept liability for any damage caused by instrument
malfunction. The manufacturer accepts no responsibility for the suitability of the
instrument to the application for which it was purchased.
Failure to install, setup or operate the instrument according to the instructions herein will
void the warranty.
Your instrument may be opened only by a duly authorized representative of the
manufacturer. The unit should only be opened in a fully anti-static environment. Failure to
do so may damage the electronic components and will void the warranty.
NOTE
The greatest care has been taken to manufacture and calibrate your instrument. However,
these instructions do not cover all possible contingencies that may arise during
installation, operation or maintenance, and all details and variations of this equipment are
not covered by these instructions.
For additional information regarding installation, operation or maintenance of this
instrument, contact the manufacturer or your local representative or distributor.
IMPORTANT
Please read instructions contained in this manual before performing
installation, and take note of the following precautions:
1.
Ensure that all incoming AC power and other power sources are turned OFF
before performing any work on the instrument. Failure to do so may result in serious
or even fatal injury and/or equipment damage.
2.
Before connecting the instrument to the power source, check the labels on the
side of the instrument to ensure that your instrument is equipped with the appropriate
power supply voltage, input voltages, currents, analog output and communication
protocol for your application.
3.
Under no circumstances should the instrument be connected to a power
source if it is damaged.
4.
To prevent potential fire or shock hazard, do not expose the instrument to
rain or moisture.
2
Introduction
Advertisement
Table of Contents
