Satec System 295 Installation And Operation Manual page 157

Iaux max = 1.2
Pmax = (Imax
Pmax = (Imax
or 3LL3
Á Power readings with a decimal point are displayed in MW, Mvar, MVA.
 The actual frequency range is 45.0 - 65.0 Hz
à The date format can be customized.
Ä New absolute value (lag or lead).
Å Release limit not used.
Æ Operate limit for the voltage disturbance trigger specifies the voltage deviation allowed
in percentage of nominal (full scale) voltage, which refers to line-to-line voltage in a
3DIR wiring mode, and to line-to-neutral voltage in other modes. The nominal voltage is
120V RMS for instruments with the 120V input option, and 380V RMS for instruments
with the 660V input option.
Table B-8 Setpoint Conditions
Label Operate condition
GE Greater or equal (over
operate limit)
LE Less or equal (under
operate limit)
Eq Equal
nE Not equal
On ON
OFF OFF
nEU NEW min/max value
Table B-9 Setpoint Actions
Action type
Label Description
nonE No action
SEt.E Set user event flag
rES.E Reset user event flag
rEL Operate relay
Inc.C Increment counter
dEc.C Decrement counter
Appendix B Programmable Parameters
×
Auxiliary CT primary current [mA/A]
× ×
Vmax 3)/1000 [kW] @ Wiring mode 4Ln3 or 3Ln3
× ×
Vmax 2)/1000 [kW] @ Wiring mode 4LL3, 3OP2, 3dir, 3OP3,
Release condition
Less or equal (under
release limit)
Greater or equal (over
release limit)
Not equal
Equal
OFF
ON
n/a
nonE
FLG.1 - FLG.8
FLG.1 - FLG.8
rEL.1 - rEL.4
Cnt1 - Cnt8
Cnt1 - Cnt8
Both limits active
Both limits active
Release limit not used
Release limit not used
Both limits not used
Both limits not used
Both limits not used
Action target
Range
No target
Flag number
Flag number
Relay number
Counter number
Counter number
Limits
Description
149