Table of Contents
Advertisement
3.3.3 Menu Map
Figure 3-2 shows a map illustrating the PM295 menus. Setup groups are accessed
via 13 primary menus that are selected by main menu entries. For setup groups, a
map shows the abbreviated labels of menu entries accented with boldface. Primary
menus can have enclosed secondary menus and sub-menus. Menu dependent
information is provided in this manual for each setup group individually.
To enter the main menu, you should select an access mode that specifies an
authorization level for setup operation. Entering the view level allows you to inspect
all setups, but does not permit changes in setup configuration. To change setup
parameters, you should enter the main menu at the protected level. If password
protection is enabled, you will be prompted to enter a password.
3.3.4 Entering/Quitting Programming Mode
To enter programming mode from operational mode:
Ä Press
SELECT
The first menu you enter from operational mode provides a selection of the
ACCESS LEVEL
labeled button-windows, as shown in the following illustration. The
you pass into the view level, allowing to inspect the present setup configuration. The
entry lets you pass into the protected level allowing the changing of
CHG
programmable setups and the performing of management procedures.
SEE
CHG
ESC
To quit programming mode and return to operational mode:
Ä Press
SELECT
Ä Press
.
ENTER
Operating The PM295
.
for setup operation. The menu has three entries indicated by
To enter the view level:
Ä Press
SELECT
Ä Press
ENTER
To enter the protected level:
Ä Press
SELECT
Ä Press
ENTER
to choose the ESC window.
to choose the
SEE
.
to choose the CHG window.
.
entry lets
SEE
window.
35
Advertisement
Table of Contents
