PLATFORM_WCCP Messages
PLATFORM_WCCP Messages
This section contains platform Web Cache Communication Protocol (WCCP) messages.
Error Message PLATFORM-WCCP-3-NO_LABEL: Cannot allocate WCCP Label
Note
Error Message PLATFORM-WCCP-4-SDM_MISMATCH: WCCP requires sdm template routing
Note
PM Messages
This section contains the port manager messages. The port manager is a state machine that controls all
the logical and physical interfaces. All features, such as VLANs, UDLD, and so forth, work with the port
manager to provide switch functions.
Error Message PM-2-LOW_SP_MEM: Switch process available memory is less than [dec]
bytes.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-62
This message applies only to the Catalyst Switch Module 3110.
The WCCP label could not be allocated. This means that the hardware cannot be
Explanation
programmed to implement WCCP redirection.
Reduce the number of interfaces configured for WCCP redirection or policy
Recommended Action
based routing.
This message applies only to the Catalyst Switch Module 3110.
To support this feature, you need to enable the Switch Database Management (SDM)
Explanation
routing template.
Modify the SDM template to enable the routing template. Use the sdm prefer
Recommended Action
routing global configuration command, and then reload the switch by using the reload privileged
EXEC command.
The available memory for the switch processor is low. This can occur when too many
Explanation
Layer 2 VLANs are configured. [dec] is the available memory.
Remove features from the system to reduce memory usage.
Recommended Action
Chapter 2
Message and Recovery Procedures
OL-12191-01