Message Severity Levels - Cisco 3110 Message Manual

How to Read System Messages
Table 1-1 Facility Codes (continued)
Facility Code
STACKMGR
STORM_CONTROL
SUPERVISOR
SUPQ
SW_DAI
SW_MACAUTH
SW_QOS_TB
SW_VLAN
TCAMMGR
UDLD
UFAST_MCAST_SW
VQPCLIENT
WCCP
•
Table 1-2
Severity Level
0 – emergency
1 – alert
2 – critical
3 – error
4 – warning
5 – notification
6 – informational
7 – debugging
•
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
1-4
Description
Stack manager (only the Catalyst
Switch Module 3110)
Storm control
Supervisor ASIC
Supervisor queue
Dynamic ARP inspection
MAC address authentication
QoS trusted boundary
VLAN manager
Ternary content addressable memory
manager
UniDirectional Link Detection
UplinkFast packet transmission
VLAN Query Protocol client
Web Cache Communication Protocol
(WCCP)
SEVERITY is a single-digit code from 0 to 7 that reflects the severity of the condition. The lower
the number, the more serious the situation.

Message Severity Levels

MNEMONIC is a code that uniquely identifies the message.
Location
"STACKMGR Messages" section on page 2-89
"STORM_CONTROL Messages" section on
page 2-92
"SUPERVISOR Messages" section on page 2-92
"SUPQ Messages" section on page 2-93
"SW_DAI Messages" section on page 2-94
"SW_MACAUTH Messages" section on
page 2-97
"SWITCH_QOS_TB Messages" section on
page 2-98
"SW_VLAN Messages" section on page 2-98
"TCAMMGR Messages" section on page 2-105
"UDLD Messages" section on page 2-107
"UFAST_MCAST_SW Messages" section on
page 2-109
"VQPCLIENT Messages" section on page 2-109
"WCCP Messages" section on page 2-112
Table 1-2 lists the message severity levels.
Description
System is unusable.
Immediate action required.
Critical condition.
Error condition.
Warning condition.
Normal but significant condition.
Informational message only.
Message that appears during debugging only.
Chapter 1 System Message Overview
OL-12191-01