Cisco 3110 Message Manual page 91

Chapter 2 Message and Recovery Procedures
Error Message QOSMGR-3-RESOURCE_INTERNAL: Internal Error in resource allocation.
Explanation
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
Error Message QOSMGR-3-VMRSEQ_INVALID: Internal Error Invalid VMR sequence.
Explanation
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
Error Message QOSMGR-4-ACTION_NOT_SUPPORTED: Action is not supported in policymap
[chars].
Explanation
commands was configured in a policy map. This is a hardware limitation. [chars] is the policy-map
name.
Recommended Action
policy-map class configuration mode.
Error Message QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not supported in
classmap [chars].
Explanation
map and attached to an egress interface, or more than one match class-map command was
configured. This is a hardware limitation. [chars] is the class-map name.
Recommended Action
dscp-list class-map configuration command in a policy map that is attached to an egress interface.
Only one match per class map is supported.
OL-12191-01
An internal software error has occurred.
Copy the message exactly as it appears on the console or in the system log.
1-6.
An internal software error has occurred.
Copy the message exactly as it appears on the console or in the system log.
1-6.
An action other than the set, trust, and police policy-map class configuration
Configure only the supported actions of set, trust, and police when in
An unsupported match class-map configuration command was configured in a policy
Reconfigure the class map or the policy map. Use only the match ip dscp
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
QOSMGR Messages
"Error Message Traceback
"Error Message Traceback
2-75