Sw_Macauth Messages - Cisco 3110 Message Manual

Catalyst switch module for ibm bladecenter system
Hide thumbs Also See for 3110:
Table of Contents

Advertisement

Chapter 2
Message and Recovery Procedures

SW_MACAUTH Messages

This section contains the MAC address authentication messages.
Error Message SW_MACAUTH-4-UNAUTH_MAC: Unauthenticated MAC [enet] on port [chars]
Error Message SW_MACAUTH-5-CLEAR_TABLE: MAC Authentication Table Cleared
Error Message SW_MACAUTH-5-MACAUTH_ENADSA: MAC Authentication [chars]
Error Message SW_MACAUTH-5-MAC_AUTHENTICATED: MAC [enet] was authenticated
SW_MATM
This section contains the Mac Address Table Manager (MATM) message.
Error Message SW_MATM-4-MACFLAP_NOTIF: Host [enet] in [chars] [dec] is flapping
between port [chars] and port [chars]
OL-12191-01
Explanation
The switch has received an unauthenticated MAC address on the specified port. [enet]
is the unauthenticated MAC address, and [chars] is the port.
No action is required.
Recommended Action
The MAC authentication table was cleared.
Explanation
No action is required.
Recommended Action
Explanation
MAC authentication is enabled or disabled. [chars] is the MAC authentication status,
either enabled or disabled.
No action is required.
Recommended Action
The switch has received a command to authenticate a MAC address. [enet] is the MAC
Explanation
address.
Recommended Action
No action is required.
The switch found the traffic from the specified host flapping between the specified
Explanation
ports. [enet] is the host MAC address, [chars] [dec] is the switch ID, and the first and second [chars]
are the ports between which the host traffic is flapping.
Check the network switches for misconfigurations that might cause a
Recommended Action
data-forwarding loop.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
SW_MACAUTH Messages
2-97

Advertisement

Table of Contents
loading

This manual is also suitable for:

3112

Table of Contents