Chapter 2
Message and Recovery Procedures
•
•
•
ACLMGR Messages
This section contains the access control list (ACL) manager messages. Most messages in this section are
the result of a switch memory shortage, which includes hardware memory and label space but not CPU
memory. Both kinds of memory shortages are described.
Error Message ACLMGR-2-NOMAP: Cannot create ACL Manager data structures for VLAN Map
[chars].
Error Message ACLMGR-2-NOVLB: Cannot create memory block for VLAN [dec].
Error Message ACLMGR-2-NOVMR: Cannot create VMR data structures for access list
[chars].
Error Message ACLMGR-3-ACLTCAMFULL: Acl Tcam Full. Drop packets on Output Acl label
[dec] on [chars] [chars].
OL-12191-01
UFAST_MCAST_SW Messages, page 2-109
VQPCLIENT Messages, page 2-109
WCCP Messages, page 2-112
Explanation
The ACL manager could not allocate the data structures needed to describe a VLAN
map in a form that can be loaded into hardware. This error is most likely caused by lack of free
memory. [chars] is the VLAN map name.
Recommended Action
Reduce other system activity to ease memory demands.
The ACL manager could not save per-VLAN information needed for its correct
Explanation
operation. Some per-interface features, such as access groups or VLAN maps, will not be configured
correctly. [dec] is the VLAN ID.
Use a less complicated configuration that requires less memory.
Recommended Action
The ACL manager was unable to allocate the value-mask result (VMR) data structures
Explanation
needed to describe an ACL in a form that can be loaded into hardware. This error is most likely
caused by lack of available memory. [chars] is the access-list name.
Recommended Action
Use a less complicated configuration that requires less memory.
Explanation
There are too many ACLs configured for the platform-specific ACL hardware table to
support. [dec] is the label number, and [chars] is the layer. The first [chars] is for Layer 3; the second
is for Layer 2. If only the Layer 2 or Later 3 hardware table is full, only one string appears, and the
other string is
.
NULL
Reduce the number of IP or MAC access lists to be applied to interfaces.
Recommended Action
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
ACLMGR Messages
2-3