Platform_Ipv6_Ucast Message - Cisco 3110 Message Manual

Chapter 2 Message and Recovery Procedures

PLATFORM_IPv6_UCAST Message

This section contains the IP Version 6 Unicast message.
Error Message PLATFORM_IPv6_UCAST-6-PREFIX: One or more, more specific prefixes
could not be programmed into TCAM and are being covered by a less specific prefix
Note
PLATFORM_PBR Messages
This section contains policy based routing (PBR) messages.
Error Message PLATFORM_PBR-2-NO_RMAP: Cannot create PBR data structures for
route-map [chars].
Error Message PLATFORM_PBR-3-INSTALL_FAIL: Policy route-map [chars] not installed in
hardware.
Error Message PLATFORM_PBR-3-NO_LABEL: Cannot allocate label for route-map [chars].
OL-12191-01
This message applies only to the Catalyst Switch Module 3110.
A more specific prefix could not be programmed into Ternary Content Addressable
Explanation
Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The
output of the show platform ipv6 unicast retry route privileged EXEC command lists the failed
prefixes.
No action is required.
Recommended Action
The PBR manager could not allocate the internal data structures for this route-map. A
Explanation
likely cause is lack of available memory. [chars] is the route-map.
Simplify the configuration so that it requires less memory.
Recommended Action
The PBR manager was unable to install the complete route-map in hardware, so the
Explanation
packets are forwarded to the CPU for processing. [chars] is the route-map.
Recommended Action Simplify route-map configurations. For example, use the same route-map on
multiple interfaces.
The PBR manager could not allocate a label for this route-map. As a result, the hardware
Explanation
cannot be programmed to implement policy routing. There is a limit of 247 labels for policy routing.
[chars] is the route-map.
Recommended Action Simplify the configuration with label sharing. Use the same route-maps on
multiple interfaces, if possible.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
PLATFORM_IPv6_UCAST Message
2-53