Chapter 2
Message and Recovery Procedures
IMAGEMGR Messages
This section contains image manager messages, which are related to image compatibility within the
stack.
Error Message IMAGEMGR-6-AUTO_ADVISE_SW_INITIATED: Auto-advise-software process
initiated for systems [bits: [hex]].
Note
Error Message IMAGEMGR-6-AUTO_ADVISE_SW: [chars].
Note
Error Message IMAGEMGR-6-AUTO_COPY_SW_INITIATED: Auto-copy-software process
initiated for systems [bits: [hex]].
Note
OL-12191-01
This message applies only to the Catalyst Switch Module 3110.
Systems with incompatible software have been detected in the switch stack.
Explanation
Auto-advise software informs you when not all switches in the stack are running the same software
version. The stack master then attempts to upgrade all switches running different versions to the
version that the master is running. The stack finds out whether or not software is available to be
copied to the incompatible systems and if so, advises you how to copy it. Otherwise, the system
informs you that the software on the switch stack needs to be updated. [bits [hex]] is the bit
representation of the switch number.
No action is required.
Recommended Action
This message applies only to the Catalyst Switch Module 3110.
A line of output from the auto-advise-software process is being displayed. [chars] is a
Explanation
text message reporting status of the upgrade process.
Recommended Action
No action is required.
This message applies only to the Catalyst Switch Module 3110.
Systems with incompatible software have been detected in the switch stack. The stack
Explanation
now finds out whether or not software is available to be copied to the incompatible systems and
whether or not it is appropriate to automatically copy the software. [bits [hex]] is the bit
representation of the switch number.
No action is required.
Recommended Action
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
IMAGEMGR Messages
2-43