Preface; Audience; Purpose - Cisco 3110 Message Manual

Preface

Audience

This guide is for the networking professional using the Cisco IOS command-line interface (CLI) to
manage the standalone Cisco Catalyst Switch Module 3110 for IBM BladeCenter, Cisco Catalyst Switch
Module 3012 for IBM BladeCenter, or the Catalyst Switch Module 3110 stack, referred to as the switch.
Before using this guide, you should have experience working with the Cisco IOS commands and the
switch software features. Before using this guide, you should have experience working with the concepts
and terminology of Ethernet and local area networking.
The Catalyst Switch Module 3110 is also referred to as a stacking-capable switch, and the Catalyst
Switch Module 3012 is referred to as a nonstacking-capable switch.
You install the switch in the IBM BladeCenter server chassis, referred to as the enclosure. For
information about the supported IBM BladeCenter server chassis, see your chassis documentation.

Purpose

This guide describes only the Catalyst Switch Module 3110 and Catalyst Switch Module 3012-specific
system messages that you might encounter. For a complete list of Cisco IOS system error messages, see
the Cisco IOS Software System Error Messages, Cisco IOS Release 12.2 available from the Cisco.com
home page by selecting Technical Support & Documentation > Documentation > Cisco IOS
Software.
This guide does not describe how to install your switch or how to configure software features on your
switch. It also does not provide detailed information about commands that have been created or changed
for use by the switch. For hardware installation information, see the hardware installation guide that
shipped with your switch. For software information, see the software configuration guide and the
command reference for this release.
For documentation updates, see the release notes for this release.
OL-12191-01
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
vii