Ufast_Mcast_Sw Messages - Cisco 3110 Message Manual

Chapter 2 Message and Recovery Procedures

UFAST_MCAST_SW Messages

This section contains UplinkFast (UFAST) packet transmission messages.
Error Message UFAST_MCAST_SW-3-PROC_START_ERROR: No process available for
transmitting UplinkFast packets.
Error Message UFAST_MCAST_SW-4-MEM_NOT_AVAILABLE: No memory is available for
transmitting UplinkFast packets on Vlan [dec].
VQPCLIENT Messages
This section contains VLAN Query Protocol (VQP) client messages.
Error Message VQPCLIENT-2-CHUNKFAIL: Could not allocate memory for VQP.
Error Message VQPCLIENT-2-DENY: Host [enet] denied on interface [chars].
OL-12191-01
UplinkFast packets will not be sent because the process could not be created.
Explanation
Recommended Action UplinkFast does not work unless you reload the switch software. If this
problem persists even after reload, find out more about the error by using the show tech-support
privileged EXEC command and by copying the error message exactly as it appears on the console or
system log and entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported
problems. For more information about these online tools and about contacting IBM, see the
Message Traceback Reports" section on page
Explanation UplinkFast packets will not be sent on a VLAN due to memory limitations. [dec] is the
VLAN ID.
Reduce other system activity to ease memory demands.
Recommended Action
An error occurred when the system tried to allocate memory for the VQP client.
Explanation
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
The VLAN Membership Policy Server (VMPS) has denied access for the given host
Explanation
MAC address to an interface. [enet] is the host MAC address, and [chars] is the interface name.
No action is normally required. If you think that the host should have been
Recommended Action
allowed access, verify the configuration on the VMPS.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
1-6.
1-6.
UFAST_MCAST_SW Messages
"Error
"Error Message Traceback
2-109