Cisco 3110 Message Manual page 32

Catalyst switch module for ibm bladecenter system
Hide thumbs Also See for 3110:
Table of Contents

Advertisement

DHCP_SNOOPING Messages
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED_N: DHCP snooping binding
transfer failed ([dec]). [chars].
Explanation
failure [dec] is the number of failures, and [chars] is the reason for the failure. This message is
rate-limited.
Recommended Action
Error Message DHCP_SNOOPING-4-DHCP_SNOOPING_ERRDISABLE_WARNING: DHCP Snooping
received [dec] DHCP packets on interface [chars].
Explanation
put the interface in the error-disabled state. [dec] is the number of DCHP packets, and [chars] is the
interface.
Recommended Action
Error Message DHCP_SNOOPING-4-DHCP_SNOOPING_PVLAN_WARNING: DHCP Snooping
configuration may not take effect on secondary vlan [dec]. [chars]
Explanation
primary VLAN automatically propagates to all the secondary VLANs. [dec] is the VLAN ID of the
secondary VLAN, and [chars] is the warning.
Recommended Action
Error Message DHCP_SNOOPING-4-IP_SOURCE_BINDING_NON_EXISTING_VLAN_WARNING: IP
source binding is configured on non existing vlan [dec].
Explanation
been configured yet. [dec] is the VLAN.
Recommended Action
Error Message DHCP_SNOOPING-4-IP_SOURCE_BINDING_PVLAN_WARNING: IP source filter may
not take effect on secondary vlan [dec] where IP source binding is configured.
[chars].
Explanation
automatically propagates to all secondary VLANs. [dec] is the secondary VLAN, and [chars] is the
warning.
Recommended Action
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-16
The DHCP snooping binding transfer process failed because of the specified reason for
No action is required.
The switch detected a DHCP packet rate-limit violation on the specified interface and
No action is required.
If the private VLAN feature is configured, the DHCP snooping configuration on the
No action is required.
The message means that an IP source binding was configured on a VLAN that has not
No action is required.
If private VLANs are configured, the IP-source-guard filter on the primary VLAN
No action is required.
Chapter 2
Message and Recovery Procedures
OL-12191-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

3112

Table of Contents